Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

FF01
Tech: Ivana Vu

Pre-flight: 
-SATCOM inop (groundbot not connected on HexChat, although Chris was getting Aeros packets once a minute on ground)

Flight 1:
-2DS and HVPS lost power after takeoff, likely due to luggage bumping into power cables. Powered on after moving luggage and resetting circuit breakers.


Fuel Stop (in Sioux Falls, IA):
-Cameras turned off and ethernet cable unplugged/plugged back in
-APU on, ADS power stayed on
-Wing probes turned off to prevent overheating
-Balanced dewpointers
-SATCOM troubleshooting: switch reset, circuit breakers reset, CISCO router reset
-HOLODEC: camera tip heater lost connection after landing


Flight 2:
1900: SATCOM switch and circuit breakers reset
1905: Hexchat worked for a few minutes, then cut out again
1910: HOLODEC camera tip heaters connected again
2040: SATCOM switch and circuit breakers reset, still inop
2109: DSMTEMP 325 shows -2400 degrees C
2111: Aeros data not updating but Nimbus data still updating
2250: Turned WCR power on to keep warm

-----

Email from Chris about SATCOM:

Here are the connections from comsat today:

Image Added

Mostly connected.   Seems like the router was not dialing, even though Ivana rebooted it on the ground.  We had an active session until a few minutes after take off and that is it.


-----