Page History

...

Today, swapped ports 5&6 to get the soil/snow motes right
Today, also moved TS036 (10cm) from the "snow" to the "soil" mote
Found that the Tsoil that I read as TS17 is reporting as TS47. Have just updated the config on "d" and Gary propagated into git.
But, as of yesterday morning, all Tsoils stopped getting to qctables, even though sensors are running on DSM. (Other soils are fine.) (
data_dump -i 10,1289 -p works, but prep -D Tsoil.9.4cm.d -f sock:localhost doesn't). A restart of statsproc today seemed to get these going.
Apogee now mounted and reporting
no Tsnows yet

...

had to pio cycle 3 to get the nano to report
Gary saw error flags on the 3m EC100. All looked okay yesterday, though the co2 levels are quite low – maybe nidas limit checking was setting flags. However, now I see no evidence of it at all in qctables. Found that it was reading all FF, but came back to good values with a power cycle. Still running a day later.
Apogee now mounted and reporting
no Tsnows yetwill be installed here.

uw:

c:

cu, ct are mounted, power and network cables connected, but not running. Rerouting DC power fixed this. Now all DSMs are up and reporting.
cb, cl, cm mounted and running
TRHs from 1–10m mounted and running
snow nanos connected (but no inlets set up). Need to attach tubing, then leave for Jessica in January.
flowcapts mounted, but not yet connected (need code to handle 2 such USB devices in one DSM). Gary got these running.
4 pillows are now in place, two responding and two not yet connected3 responding and reporting. The 4th (#1) electronics box doesn't read the load. Jessica is investigating.
Apogee now mounted and reportingno Tsnows yet
need to figure out if sonic or EC150 should be mounted at 1.5m. Deferred until later.

Other:

where to add webcam? d.5m. Done and reporting
add NR01 & wetness to qctables (tried NR01R's work, but not workingTcase not, since no separate in and out)
add second Victron to cl (done mostly, but need to change names in qctables)

...

Blog